CO2 Laser Power Supply for 100-120W Laser Engraver Laser Tube Cutting Marking. HY-DY13 CO2 laser engraving and cutting machine power supply 110V compatible with RECI Z4 / W4 / S4 100-120w laser tube, also suitable for EFR, YONGLI, WEEGAINT, SP and other lasers. The power supply itself can be equipped with a feedback interface that can be used for closed-loop control as well as for verifying the actual operating current of the laser. Simple control and high reliability.
High and low level control laser start and stop; at the same time, the protection switch detects water flow. Laser power control is simple.
Both the analog signal 0-5V can be used to control the laser power, or it can be controlled by digital signals. The power supply itself has an.
It is safer to use and significantly extends the life of the power supply. Power stable, adaptable and fast response, suitable for cutting or engraving. The power supply has a. To quickly determine the fault on site.Dimension:34.5024.0016.50cm. Mean time between failures: greater than 10,000 hours. (from the time the switching signal is given until the output current rises to 90% of the set current). Withstand voltage: input-output, input-case: AC1500V 10mA 60S; output negative is connected to the case. TTL electric evaluation switch control. Effective level can be high or low selection. Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal.
We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount.
Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. This item is in the category "Business & Industrial\Printing & Graphic Arts\Screen & Specialty Printing\Engraving".The seller is "denestcoltd" and is located in this country: US. This item can be shipped to United States.